brake fluid type JEEP GRAND CHEROKEE 2007 WK / 3.G Owners Manual

Brake Master Cylinder — Brake Fluid Level Check
The fluid level of the master cylinder should be checked
when performing under the hood service, or immedi-
ately if the brake system warning lamp indicates system
failure.
The brake master cylinder has a translucent plastic
reservoir. On the outboard side of the reservoir, there is a
“MAX” dot and an “MIN” dot. The fluid level must be
kept within these two dots. Do not add fluid above the
MAX mark, because leakage may occur at the cap.
With disc brakes the fluid level can be expected to fall as
the brake linings wear. However, an unexpected drop in
fluid level may be caused by a leak and a system check
should be conducted.
Refer to Fluids, Lubricants and Genuine Parts for the
correct fluid type.WARNING!
Use of a brake fluid that may have a lower initial
boiling point, or is unidentified as to specification,
may result in sudden brake failure during hard
prolonged braking. You could have an accident.
WARNING!
Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts and the
brake fluid catching fire.
Use only brake fluid that has been in a tightly closed
container to avoid contamination from foreign matter or
moisture.
384 MAINTAINING YOUR VEHICLE

CAUTION!
Do not allow a petroleum-base fluid to contaminate
the brake fluid. Seal damage may result.
Front/Rear Axle Fluid
Front Axle Fluid Level Check
Lubricant should be to the bottom of the oil fill hole.
Rear Axle Fluid Level Check
Lubricant should be 1/2” (1 cm) below the oil fill hole.
Adding Fluid
Add lubricant only at the fill hole and only to the level
specified above.
Selection of Lubricant
Use only manufacturer’s recommended fluid, refer to
Fluids, Lubricants, and Genuine Parts for correct fluid
type.
Transfer Case
Fluid Level Check
Inspect the transfer case for fluid leaks. If a fluid leak is
found, the transfer case fluid level can be checked by
removing the filler plug located on the back side of the
transfer case. The fluid level should be at the bottom edge
of the filler plug hole when the vehicle is in a level
position.
Adding Fluid
Add fluid at the filler hole until it runs out of the hole
when the vehicle is in a level position.
Drain
First remove fill plug, then remove drain plug. Recom-
mended tightening torque for drain and fill plugs is
15–25 ft. lbs (20–34 N·m).
MAINTAINING YOUR VEHICLE 385
7

ABS (Anti-Lock Brake System)............176,274
Adding Fuel........................... 313
Adding Washer Fluid..................... 165
Adjustable Pedals....................... 124
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 367
Air Conditioner Maintenance............... 371
Air Conditioning........................ 235
Air Conditioning, Operating Tips............ 242
Air Conditioning Refrigerant............... 372
Air Conditioning System.................. 235
AirFilter .............................. 367
Air Pressure, Tires....................... 288
Airbag................................ 43
Airbag Deployment....................... 50
Airbag Light....................... 52,66,176
Airbag Maintenance....................... 51
Alarm (Security Alarm)................. 18,177
Alarm System (Security Alarm)............... 18
Alignment and Balance................... 293Alterations/Modifications, Vehicle............. 9
Antenna, Satellite Radio................... 230
Antifreeze (Engine Coolant)................ 407
Anti-Lock Brake System (ABS)............129,274
Anti-Lock Warning Light.................. 176
Anti-Theft System..................... 18,177
Appearance Care........................ 389
Auto Down Power Windows................ 30
AutomaticDimmingMirror ................. 72
Automatic Door Locks..................... 27
Automatic Headlights..................... 114
Automatic Temperature Control (ATC)......... 236
Automatic Transmission................254,386
Adding Fluid......................... 387
Fluid and Filter Changes................. 386
Fluid Level Check...................... 386
FluidType ........................... 386
Special Additives...................... 388
Torque Converter...................... 260
452 INDEX